On their way to the scrap yard
Moderator: Kurt Lesser
-
- Jeep Heaven
- Posts: 49841
- Joined: Sun Mar 02, 2008 12:37 pm
- Location: Proving Ground
Re: On their way to the scrap yard
The facility at the now closed Loring Air Force Base is run by the support personnel of the Maine Army Guard, many of the technicians are civilians. They submit bits to DOD on the rebuilding, they are highly competitive and have performed the task cheaper and more efficiently than some of the Army Depots. Many of the technicians are farm boys that bring the Aroostook County work ethic with them. M-110 SP Guns, 5 Tons, Cat Dozers, and Humvees appear to be the norm.
2011 MVPA PIONEER AWARD - MVPA #1064
HONOR GRAD-WHEELED VEHICLE MECHANIC SCHOOL 1960 - US ARMY ORDNANCE SCHOOL(MACHINIST) ABERDEEN PG 1962 - O-1 BIRD DOG CREWCHIEF - 300,000+TROUBLE FREE M-38A1 MILES
LIFE MEMBER AM LEGION-40/8-DAV
7 MIL SPEC MAINTAINED MV'S
COL. BRUNO BROOKS (ARMY MOTORS) IS MY HERO
HONOR GRAD-WHEELED VEHICLE MECHANIC SCHOOL 1960 - US ARMY ORDNANCE SCHOOL(MACHINIST) ABERDEEN PG 1962 - O-1 BIRD DOG CREWCHIEF - 300,000+TROUBLE FREE M-38A1 MILES
LIFE MEMBER AM LEGION-40/8-DAV
7 MIL SPEC MAINTAINED MV'S
COL. BRUNO BROOKS (ARMY MOTORS) IS MY HERO
- Hell On Wheels
- G-Colonel
- Posts: 1529
- Joined: Fri May 04, 2007 1:19 pm
- Location: San Antonio, TX
- Contact:
Re: On their way to the scrap yard
I would agree Red River could rebuild these HMMWV, but to ship down (south) Ft Sam from Ft Hood then north again, no I don’t think so, especially Ft Hood has one of the best railheads in the Army and would have been shipped directly. Though I have questioned a lot of things the Army will do! Government Liquidations buys these for about $50.00 to $200.00 dollars, from my inside connection. They buy these sell them off for scarp. If they end up here they are civilian contracted to be DE milled or scraped. I do remember when I returned from Iraq it took over 12 months to get our vehicles back from the refit program out of Ft Hood. As mentioned before the cost to refurbish far exceeds the cost of ownership. The cost analysis is based on its life cycle that the government had determined to scrap these puppies.Bob Shaw wrote:Yes, DoL has the capability ,and does so every day.Red River Army Depot does as well.I would be willing to bet they end up here or there.If here that is just a bit more job security for me.
Robert
1966 - M151A1
1986 - M998
2007 - M1102
2009 - H3T
Hell on Wheels https://www.youtube.com/channel/UCi_blL ... z7Ukw8gbHg
1966 - M151A1
1986 - M998
2007 - M1102
2009 - H3T
Hell on Wheels https://www.youtube.com/channel/UCi_blL ... z7Ukw8gbHg
- Hell On Wheels
- G-Colonel
- Posts: 1529
- Joined: Fri May 04, 2007 1:19 pm
- Location: San Antonio, TX
- Contact:
Re: On their way to the scrap yard
Hey my friend works in DOL used to be the tank shop, Mark Benefied, you know?Bob Shaw wrote:That seems odd. We rebuild them up here at Fort Hood all the time.I know I see trucks headed to Red River Army Depot loaded with the all the time for refit and rebuild.
Robert
1966 - M151A1
1986 - M998
2007 - M1102
2009 - H3T
Hell on Wheels https://www.youtube.com/channel/UCi_blL ... z7Ukw8gbHg
1966 - M151A1
1986 - M998
2007 - M1102
2009 - H3T
Hell on Wheels https://www.youtube.com/channel/UCi_blL ... z7Ukw8gbHg
- unclesamsurplus
- Sergeant Major of the Gee
- Posts: 375
- Joined: Wed Mar 01, 2006 4:28 pm
- Location: mississippi
Re: On their way to the scrap yard
Using soldiers to rebuild them would have bveen too cost effective i guess. Every government contractor overcharges. Take a look at the aquisition cost on every item on government liquidation. $10,000. for a toilet bowl.
- Hell On Wheels
- G-Colonel
- Posts: 1529
- Joined: Fri May 04, 2007 1:19 pm
- Location: San Antonio, TX
- Contact:
Re: On their way to the scrap yard
You hit the nail on the head; the cost to rebuild far exceeds the use.unclesamsurplus wrote:I've been to Red River and seen the hmmwv's being rebuilt. There were hundreds of trucks in the junkyard in every configuration. However the rebuilding is done mostly by civilians and I'm sure private contractors are overcharging the govt. I recantly read an article about the future of the program decided by genius's in washington. The article is dated January 2012. see here...
http://www.dodbuzz.com/2012/01/24/repor ... s-on-jltv/
Robert
1966 - M151A1
1986 - M998
2007 - M1102
2009 - H3T
Hell on Wheels https://www.youtube.com/channel/UCi_blL ... z7Ukw8gbHg
1966 - M151A1
1986 - M998
2007 - M1102
2009 - H3T
Hell on Wheels https://www.youtube.com/channel/UCi_blL ... z7Ukw8gbHg
- Hell On Wheels
- G-Colonel
- Posts: 1529
- Joined: Fri May 04, 2007 1:19 pm
- Location: San Antonio, TX
- Contact:
Re: On their way to the scrap yard
Well just to give everyone an update, "Yes" they are off to the scrap yard . When I picked up my trailer, I went to go talk to the yard boss and he said in a few weeks a trucking company was hired to haul these off to the scrap yard. I poked around and most of these vehicles start and run. They are from 3rd ACR unit as was my trailer. He was amazed to see the condition of my HMMWV as it was the same year model as most of these were. He wanted me to write my congressman and complain about how much money the government could make to resale. So I gave him the story of AMG wanting them off the street and how many vehicles we left behind in Iraq when my unit redepoyed back in 2005. What a shame
Robert
1966 - M151A1
1986 - M998
2007 - M1102
2009 - H3T
Hell on Wheels https://www.youtube.com/channel/UCi_blL ... z7Ukw8gbHg
1966 - M151A1
1986 - M998
2007 - M1102
2009 - H3T
Hell on Wheels https://www.youtube.com/channel/UCi_blL ... z7Ukw8gbHg
- Hell On Wheels
- G-Colonel
- Posts: 1529
- Joined: Fri May 04, 2007 1:19 pm
- Location: San Antonio, TX
- Contact:
Re: On their way to the scrap yard
Update, say good by folks, lets band togther and bid.
http://www.govliquidation.com/auction/v ... vertTo=USD" onclick="window.open(this.href);return false;
This is a term contract for 10,000,000 lbs. (5000 Tons) of Aluminum HMMV s Armored and Unarmored Wheeled Vehicles. These vehicles are located at Red River Army Depot. The Term Contract will be based on advertised weight of vehicles and not by length of time. ABSOLUTELY NO PARTS REMOVAL AUTHORIZED!! These vehicles are Demil C; an approved End-Use-Certificate (EUC) will be required before any vehicle removal can occur. Vehicles must be demilitarized on-site;
http://www.govliquidation.com/auction/v ... vertTo=USD" onclick="window.open(this.href);return false;
This is a term contract for 10,000,000 lbs. (5000 Tons) of Aluminum HMMV s Armored and Unarmored Wheeled Vehicles. These vehicles are located at Red River Army Depot. The Term Contract will be based on advertised weight of vehicles and not by length of time. ABSOLUTELY NO PARTS REMOVAL AUTHORIZED!! These vehicles are Demil C; an approved End-Use-Certificate (EUC) will be required before any vehicle removal can occur. Vehicles must be demilitarized on-site;
Robert
1966 - M151A1
1986 - M998
2007 - M1102
2009 - H3T
Hell on Wheels https://www.youtube.com/channel/UCi_blL ... z7Ukw8gbHg
1966 - M151A1
1986 - M998
2007 - M1102
2009 - H3T
Hell on Wheels https://www.youtube.com/channel/UCi_blL ... z7Ukw8gbHg
-
- G-Lieutenant General
- Posts: 5181
- Joined: Mon Feb 06, 2006 3:19 pm
- Location: East Tennessee
- Contact:
Re: On their way to the scrap yard
small problem with this...
You cannot let them accumulate for more than one day. So, you will need to have enough people to work for you and the equipment and time to spend at least a year there to be there every day...
You cannot let them accumulate for more than one day. So, you will need to have enough people to work for you and the equipment and time to spend at least a year there to be there every day...
Vehicles must be demilitarized on-site;
The buyer must be able to process 10 to 15 vehicles per day from the combined sales,
- Hell On Wheels
- G-Colonel
- Posts: 1529
- Joined: Fri May 04, 2007 1:19 pm
- Location: San Antonio, TX
- Contact:
Re: On their way to the scrap yard
It sounds like they want a local company to get this bid. Sounds odd
Robert
1966 - M151A1
1986 - M998
2007 - M1102
2009 - H3T
Hell on Wheels https://www.youtube.com/channel/UCi_blL ... z7Ukw8gbHg
1966 - M151A1
1986 - M998
2007 - M1102
2009 - H3T
Hell on Wheels https://www.youtube.com/channel/UCi_blL ... z7Ukw8gbHg
-
- G-Lieutenant Colonel
- Posts: 1120
- Joined: Thu Sep 07, 2006 7:31 pm
- Location:
Re: On their way to the scrap yard
i saw this the other day....and cried.
FS
FS
- dilvoy
- G-Lieutenant General
- Posts: 6185
- Joined: Tue May 18, 2004 4:28 pm
- Location: San Francisco, Ca.
Re: On their way to the scrap yard
There have been a couple of old school HMMWV's at the local National Guard Yard near me. One is an Ambulance and the other is an M998 both in really nice looking condition. Pretty cool to see some early models around, but I guess they are just there until they get taken to the scrapper.
George D. Paxinos
M998
M1123A2
M998
M1123A2
-
- G-First Sergeant
- Posts: 139
- Joined: Mon Aug 06, 2007 8:39 pm
- Location: Pittsburgh, PA / Elizabeth
Re: On their way to the scrap yard
Look at the other lot in that sale. Sure would like a HETT.
HMMWV
Have owned or worked on,
M151, M35
M880, M52
CUCV
M925
M998
M996
Have owned or worked on,
M151, M35
M880, M52
CUCV
M925
M998
M996
-
- G-Lieutenant Colonel
- Posts: 1120
- Joined: Thu Sep 07, 2006 7:31 pm
- Location:
Re: On their way to the scrap yard
Wow.....darn.
- dilvoy
- G-Lieutenant General
- Posts: 6185
- Joined: Tue May 18, 2004 4:28 pm
- Location: San Francisco, Ca.
Re: On their way to the scrap yard
Hell On Wheels wrote:Update, say good by folks, lets band togther and bid.
http://www.govliquidation.com/auction/v ... vertTo=USD" onclick="window.open(this.href);return false;
This is a term contract for 10,000,000 lbs. (5000 Tons) of Aluminum HMMV s Armored and Unarmored Wheeled Vehicles. These vehicles are located at Red River Army Depot. The Term Contract will be based on advertised weight of vehicles and not by length of time. ABSOLUTELY NO PARTS REMOVAL AUTHORIZED!! These vehicles are Demil C; an approved End-Use-Certificate (EUC) will be required before any vehicle removal can occur. Vehicles must be demilitarized on-site;
Some demil regulations require armor pieces to be cut into pieces no larger than 26"x26" or something close to that. They don't allow precision cutting with saws either. Probably only torch cutting and giant snipper machines or maybe those big shredder machings similar to brush shredders but way bigger. It would be nice if 100,000 humvees were suplussed to the public instead of being scrapped. I'd buy as many as I had money or space for, but I won't hold my breath waiting for that.
George D. Paxinos
M998
M1123A2
M998
M1123A2
- Ted Gates
- G-Major General
- Posts: 2667
- Joined: Sun Dec 15, 2002 12:13 pm
- Location: Eaton Rapids, MI
Re: On their way to the scrap yard
Buy tubs, frame assemblies, doors and tops when you find them. They will be gone one day due to the shedder and the rules that are in place to keep them out of the public.
Who is online
Users browsing this forum: No registered users and 53 guests