If you are seeing this message, you are viewing the G on it's new server. Users should notice a marked improvement in
performance and response times, as well as an elimination of the annoying "maintenance" messages. Thank you for your patience.
This was a new radiator I bought and used during my engine rebuild. It was run while the engine was on jackstands and then later on wheels with drive shafts disconnected. It has no road miles on it. I had my radiator repaired that came with the jeep and when I got a shroud ( I am not sure it was for a 3a) I couldn't get it to fit this radiator but did get it to fit my original radiator with some modifying. There are 2 small holes drilled where I thought shroud would attach but otherwise it is like I got it. it fits the sidemount grill set up. It is made by Radphil. Asking 200.00 plus shipping. Any other pics or questions just e-mail or pm me.
I am in Fort Myers, Fl. The shroud I bought was a used shroud and I had to cut the bottom of it to fit on my original radiator that I had cleaned. I am not sure that it was a 3a shroud but I made it fit. the radiator that I am selling fit to my grill just as it should. I hope that clarifyed it better. If you need any measurements or better pic's I can get them.