Tall guy in M 38 A 1
-
- G-First Sergeant
- Posts: 129
- Joined: Tue Mar 14, 2017 4:19 pm
- Location:
Re: Tall guy in M 38 A 1
Hi Guys,
Well......my 55 A1, which is my first military jeep (or any kind of jeep) arrived last night and I got to drive one for the first time. I'm 6'1" and 185 lbs. I felt like I was driving from inside an ATM machine! You guys actually drive these things for more than 10 or 15 minutes at a time? My hat's off to you. First order of business, once I get it to stop puking lubes all over my nice clean driveway, is to move that seat back. I've read it's pretty impossible.......but it's going back. I haven't dug into this in detail, but I think I can move the sheetmetal seat back from the front of the frame to the back of the frame and pick up an inch or two to start. I'll pull the cover off later. I won't destroy my original seat frame, I'll pick up a junker or an Omix at one of the meets in a few weeks. I also have to re-route the fuel sender wire, as right now it catches my foot entering and exiting. Other than that it's a "cozy" driving position for sure.
regards,
bob
Well......my 55 A1, which is my first military jeep (or any kind of jeep) arrived last night and I got to drive one for the first time. I'm 6'1" and 185 lbs. I felt like I was driving from inside an ATM machine! You guys actually drive these things for more than 10 or 15 minutes at a time? My hat's off to you. First order of business, once I get it to stop puking lubes all over my nice clean driveway, is to move that seat back. I've read it's pretty impossible.......but it's going back. I haven't dug into this in detail, but I think I can move the sheetmetal seat back from the front of the frame to the back of the frame and pick up an inch or two to start. I'll pull the cover off later. I won't destroy my original seat frame, I'll pick up a junker or an Omix at one of the meets in a few weeks. I also have to re-route the fuel sender wire, as right now it catches my foot entering and exiting. Other than that it's a "cozy" driving position for sure.
regards,
bob
- Jeeps4Brains
- G-Lieutenant Colonel
- Posts: 1082
- Joined: Wed Jul 20, 2005 8:56 am
- Location: Upstate SC
Re: Tall guy in M 38 A 1
Awh... come on! I am 6'1" and 220lbs and it is cozy but perfectly fine to drive. You learn to step in first with your right leg and slide behind the steering wheel.
You should sit in and drive a M38 or MB. Then you will think the M38A1 has lots of room.
Alan
You should sit in and drive a M38 or MB. Then you will think the M38A1 has lots of room.
Alan
45' MB, ??' MBT, 47' CJ2A, 48' CJ2A,
51' M38 #1, 51' M38 #2, 51' M100,
52' M37, ??' M101A1 (1st Gulf War Vet),
53' M38A1, 53' M211, 65' M151A1, 67' M416,
MVPA #31724
51' M38 #1, 51' M38 #2, 51' M100,
52' M37, ??' M101A1 (1st Gulf War Vet),
53' M38A1, 53' M211, 65' M151A1, 67' M416,
MVPA #31724
-
- Jeep Heaven
- Posts: 49841
- Joined: Sun Mar 02, 2008 12:37 pm
- Location: Proving Ground
Re: Tall guy in M 38 A 1
A lot of us fit Jeeps way back when during the days of the "lean mean fighting machine".
2011 MVPA PIONEER AWARD - MVPA #1064
HONOR GRAD-WHEELED VEHICLE MECHANIC SCHOOL 1960 - US ARMY ORDNANCE SCHOOL(MACHINIST) ABERDEEN PG 1962 - O-1 BIRD DOG CREWCHIEF - 300,000+TROUBLE FREE M-38A1 MILES
LIFE MEMBER AM LEGION-40/8-DAV
7 MIL SPEC MAINTAINED MV'S
COL. BRUNO BROOKS (ARMY MOTORS) IS MY HERO
HONOR GRAD-WHEELED VEHICLE MECHANIC SCHOOL 1960 - US ARMY ORDNANCE SCHOOL(MACHINIST) ABERDEEN PG 1962 - O-1 BIRD DOG CREWCHIEF - 300,000+TROUBLE FREE M-38A1 MILES
LIFE MEMBER AM LEGION-40/8-DAV
7 MIL SPEC MAINTAINED MV'S
COL. BRUNO BROOKS (ARMY MOTORS) IS MY HERO
-
- Jeep Heaven
- Posts: 49841
- Joined: Sun Mar 02, 2008 12:37 pm
- Location: Proving Ground
Re: Tall guy in M 38 A 1
Driver and Asistant Driver used to swap seats while driving when they got tired.
Even done it a few times as the Battalion Motor Officers driver.
Even done it a few times as the Battalion Motor Officers driver.
Last edited by Joe Gopan on Sat Mar 17, 2018 4:45 am, edited 1 time in total.
2011 MVPA PIONEER AWARD - MVPA #1064
HONOR GRAD-WHEELED VEHICLE MECHANIC SCHOOL 1960 - US ARMY ORDNANCE SCHOOL(MACHINIST) ABERDEEN PG 1962 - O-1 BIRD DOG CREWCHIEF - 300,000+TROUBLE FREE M-38A1 MILES
LIFE MEMBER AM LEGION-40/8-DAV
7 MIL SPEC MAINTAINED MV'S
COL. BRUNO BROOKS (ARMY MOTORS) IS MY HERO
HONOR GRAD-WHEELED VEHICLE MECHANIC SCHOOL 1960 - US ARMY ORDNANCE SCHOOL(MACHINIST) ABERDEEN PG 1962 - O-1 BIRD DOG CREWCHIEF - 300,000+TROUBLE FREE M-38A1 MILES
LIFE MEMBER AM LEGION-40/8-DAV
7 MIL SPEC MAINTAINED MV'S
COL. BRUNO BROOKS (ARMY MOTORS) IS MY HERO
-
- G-First Sergeant
- Posts: 129
- Joined: Tue Mar 14, 2017 4:19 pm
- Location:
Re: Tall guy in M 38 A 1
I know, I know.......I'm a pussy.
I didn't say it was impossible to drive, just not optimal. I sure won't fall asleep driving it, I can guarantee that. Looking at it a bit more I can see how I can move the seat back a few inches. Offset adapter plates for the right side seat frame mounts and on the left I'll have to modify the seat bottom frame and put a small dog-leg in the seat back tube on the left side......but it can be done. Now installing that reclining mechanism...........................
Hey........on the positive side I'll never complain about the driving position of my M37 again, now that's comfort!!
Happy Easter everyone!
regards,
bob
I didn't say it was impossible to drive, just not optimal. I sure won't fall asleep driving it, I can guarantee that. Looking at it a bit more I can see how I can move the seat back a few inches. Offset adapter plates for the right side seat frame mounts and on the left I'll have to modify the seat bottom frame and put a small dog-leg in the seat back tube on the left side......but it can be done. Now installing that reclining mechanism...........................
Hey........on the positive side I'll never complain about the driving position of my M37 again, now that's comfort!!
Happy Easter everyone!
regards,
bob
-
- Jeep Heaven
- Posts: 49841
- Joined: Sun Mar 02, 2008 12:37 pm
- Location: Proving Ground
Re: Tall guy in M 38 A 1
I've never had M-38/M-38A1 kits that sucked as I have been lucky to have bought a stock of OEM Carters made thru the 80's. I did loan out several of M-38 and M-38A1 OEM Carters to use as patterns for the quality kits now being marketed.
2011 MVPA PIONEER AWARD - MVPA #1064
HONOR GRAD-WHEELED VEHICLE MECHANIC SCHOOL 1960 - US ARMY ORDNANCE SCHOOL(MACHINIST) ABERDEEN PG 1962 - O-1 BIRD DOG CREWCHIEF - 300,000+TROUBLE FREE M-38A1 MILES
LIFE MEMBER AM LEGION-40/8-DAV
7 MIL SPEC MAINTAINED MV'S
COL. BRUNO BROOKS (ARMY MOTORS) IS MY HERO
HONOR GRAD-WHEELED VEHICLE MECHANIC SCHOOL 1960 - US ARMY ORDNANCE SCHOOL(MACHINIST) ABERDEEN PG 1962 - O-1 BIRD DOG CREWCHIEF - 300,000+TROUBLE FREE M-38A1 MILES
LIFE MEMBER AM LEGION-40/8-DAV
7 MIL SPEC MAINTAINED MV'S
COL. BRUNO BROOKS (ARMY MOTORS) IS MY HERO
- dpcd67
- G-General
- Posts: 11866
- Joined: Mon Jul 25, 2011 3:41 pm
- Location: Iowa
Re: Tall guy in M 38 A 1
Just chop out the wheelhouse and put a real seat in there; M38A1s are common enough so a little modification won't matter.
U. S. Army 28 years.
Armor Branch
Armor Branch
-
- G-First Sergeant
- Posts: 129
- Joined: Tue Mar 14, 2017 4:19 pm
- Location:
Re: Tall guy in M 38 A 1
Ouch! Someone in 20 years is gonna be pissed you suggested that.
I bought another seat frame a few weeks ago and this weekend I picked a used bottom half of the driver's seat frame to play with. A small dog bone in the left side upper frame and moving the sheetmetal backing to the rear should do the trick. I was also looking at how roomy the M151's are this weekend.
regards,
bob
I bought another seat frame a few weeks ago and this weekend I picked a used bottom half of the driver's seat frame to play with. A small dog bone in the left side upper frame and moving the sheetmetal backing to the rear should do the trick. I was also looking at how roomy the M151's are this weekend.
regards,
bob
-
- G-Sergeant
- Posts: 38
- Joined: Sun Jun 11, 2017 3:51 am
- Location:
Re: Tall guy in M 38 A 1
im 6'2" and i figured out how to more comfortably slump to see under the top of the windshield frame. dont have issues hitting the canvas top though.
have to wear regular shoes or less aggressive boots when i drive so i can reliably hit only one pedal at a time!
and the starter switch under the dash behind the shifters....oh boy.
have to wear regular shoes or less aggressive boots when i drive so i can reliably hit only one pedal at a time!
and the starter switch under the dash behind the shifters....oh boy.
-
- Jeep Heaven
- Posts: 49841
- Joined: Sun Mar 02, 2008 12:37 pm
- Location: Proving Ground
Re: Tall guy in M 38 A 1
"Short or small, big or small, M-38A1 fits them all"
The M-38A1 was the best 1/4 Ton fit available during its active military period.
The M-38A1 was the best 1/4 Ton fit available during its active military period.
2011 MVPA PIONEER AWARD - MVPA #1064
HONOR GRAD-WHEELED VEHICLE MECHANIC SCHOOL 1960 - US ARMY ORDNANCE SCHOOL(MACHINIST) ABERDEEN PG 1962 - O-1 BIRD DOG CREWCHIEF - 300,000+TROUBLE FREE M-38A1 MILES
LIFE MEMBER AM LEGION-40/8-DAV
7 MIL SPEC MAINTAINED MV'S
COL. BRUNO BROOKS (ARMY MOTORS) IS MY HERO
HONOR GRAD-WHEELED VEHICLE MECHANIC SCHOOL 1960 - US ARMY ORDNANCE SCHOOL(MACHINIST) ABERDEEN PG 1962 - O-1 BIRD DOG CREWCHIEF - 300,000+TROUBLE FREE M-38A1 MILES
LIFE MEMBER AM LEGION-40/8-DAV
7 MIL SPEC MAINTAINED MV'S
COL. BRUNO BROOKS (ARMY MOTORS) IS MY HERO
- g.keating
- Sergeant Major of the Gee
- Posts: 398
- Joined: Sat Mar 15, 2003 10:30 am
- Location:
Re: Tall guy in M 38 A 1
I would have to say the M170"s fit and ride beats any 1/4 ton in its day.
-
- G-Sergeant Major
- Posts: 164
- Joined: Thu Jan 20, 2011 4:35 pm
- Location: Memphis, Texas
- acudanut
- USMC GUNNY
- Posts: 368
- Joined: Sat Feb 19, 2011 5:47 am
- Location: Land of OZ, KANSAS
Re: Tall guy in M 38 A 1
Is that steering wheel digging into your stomach ? I went M151 and never looked back. Cheers
-
- G-Private
- Posts: 3
- Joined: Sun Jan 21, 2024 12:47 pm
- Location: Yorktown, VA
Re: Tall guy in M 38 A 1
Looking at '63 M38A1. I'm 6'3" 230...looks like I'll fit..
- dpcd67
- G-General
- Posts: 11866
- Joined: Mon Jul 25, 2011 3:41 pm
- Location: Iowa
Re: Tall guy in M 38 A 1
You guys need to forget these toy jeeps and get an M37. They will fit.
Sklv; first post I see; welcome to the forum.
Sklv; first post I see; welcome to the forum.
U. S. Army 28 years.
Armor Branch
Armor Branch
Who is online
Users browsing this forum: No registered users and 46 guests