Hood hinge replacement

1945 - 196*, Willys CJ series, modifications, sugestions, and ideas
Post Reply
JeeperJim
G-Sergeant First Class
G-Sergeant First Class
Posts: 97
Joined: Mon Aug 02, 2004 5:37 am
Location: Baton Rouge, Lousiana

Hood hinge replacement

Post by JeeperJim » Tue Sep 28, 2010 8:14 am

I posted this on the CJ2A page but realized that I forgot to put it here too.

I have the original CJ2A (1946) hood from my jeep and three of the lugs are cracked off for the hinge pin.
I purchased a new hinge about 10 years ago and was looking at finally doing the repair this weekend.
It appears that since this has two sides being signed as a replacement hinge assembly that the support rib for the hood should either be removed completely or partially so that the tab on the hood side can be welded in against the under side of the skin as opposed to just cutting a slit and inserting it into the support and welding the sides only.
I am appealing to other owners that have already replaced their hinges to the correct method for this minor surgical procedure.
It would not have me gain points if I were showing this jeep but I want it to be safe and functional as well as practical.
Jim

jeeperjim here on G503 or jeeperjim@cox.net
JeeperJim

Post Reply

Return to “CJ's Modifications”

Who is online

Users browsing this forum: No registered users and 1 guest