jerry can holders
-
- G-Captain
- Posts: 762
- Joined: Fri Mar 10, 2006 8:22 am
- Location:
jerry can holders
I have a question in regards to this part. Did ALL the ww2 holders have a id number on the bottom and are there 2 two hole on each end or just one on each end. Plus what is the ww2 metal gauge that was used thanks for any info provided
- Mark Tombleson
- MZ Radio Operator
- Posts: 9836
- Joined: Wed Dec 11, 2002 7:58 pm
- Location: Selah, Washington
Re: jerry can holders
Here is the long thread on the topic.
viewtopic.php?f=4&t=226475&hilit=A+4133
A-4123, the drawing for the WWII jeeps, shows two 3/4" holes 4-7/8 from the center on the floor of the bracket.
ID is shown on one of the pages in the above thread, page 3... I think.
The bottom and sides of the bracket are #13 (.0897) U.S.S. GA. and the U clips where the web straps attach are #18 (.0478) U.S.S. GA.. The modern equivalent is not quite the same thickness... but close.
The drawing is too large with too much detail to show but pieces of it are in the link above.
viewtopic.php?f=4&t=226475&hilit=A+4133
A-4123, the drawing for the WWII jeeps, shows two 3/4" holes 4-7/8 from the center on the floor of the bracket.
ID is shown on one of the pages in the above thread, page 3... I think.
The bottom and sides of the bracket are #13 (.0897) U.S.S. GA. and the U clips where the web straps attach are #18 (.0478) U.S.S. GA.. The modern equivalent is not quite the same thickness... but close.
The drawing is too large with too much detail to show but pieces of it are in the link above.
MB-NAVY-MZ-1 352625 - 07/20/44 (DOD est.)
U.S.N. 133818
2nd place Restored Class 2008 Portland Convention
MVPA Hall of Fame - 2013
U.S.N. 133818
2nd place Restored Class 2008 Portland Convention
MVPA Hall of Fame - 2013
Who is online
Users browsing this forum: ODAddict and 46 guests