WTS: 01-42 Dated Slat Grill Engine - Machine Work Complete
Posted: Fri Jan 06, 2017 8:58 pm
Have a Jan 1942 dated (machine work done) Willys Slat Grill engine with all machine work done. THe following has been completed.
Hardened Exhaust Valve Guides and Seats installed
Complete Valve Job
Crank was spec and then polished
New cam shaft bearings installed and cam installed
Tappets were check, ground if possible, replaced if out of spec
Top of block surface was machined
Cylinder head was machined (correct head for engine date)
Cylinders were checked for roundness and then check for piston clearance using original pistons that will go into it.
Engine is complete minus waterpump, gen, distributor. Has correct oil pan with riveted drain plug fitting.
Can not recall number stamped on side but was a factory replacement engine. Also, has 1944 dated Fort Devon rebuild tag on side.
SPF
Hardened Exhaust Valve Guides and Seats installed
Complete Valve Job
Crank was spec and then polished
New cam shaft bearings installed and cam installed
Tappets were check, ground if possible, replaced if out of spec
Top of block surface was machined
Cylinder head was machined (correct head for engine date)
Cylinders were checked for roundness and then check for piston clearance using original pistons that will go into it.
Engine is complete minus waterpump, gen, distributor. Has correct oil pan with riveted drain plug fitting.
Can not recall number stamped on side but was a factory replacement engine. Also, has 1944 dated Fort Devon rebuild tag on side.
SPF