Well, with the help of many individuals and Vendors, I have been able to obtain the parts to assemble the Military eight groove serpentine belt system. I had to take a non A/C pulley plate and cut out the notch for the A/C compressor, but it worked out very well, with only 1/8" of front to back slop when mounting the A/C pump and that was easily taken care of when I tightened everything up. Thanks everyone.
Serpentine Belt installation
Moderator: Kurt Lesser
- dilvoy
- G-Lieutenant General
- Posts: 6185
- Joined: Tue May 18, 2004 4:28 pm
- Location: San Francisco, Ca.
Serpentine Belt installation
Last edited by dilvoy on Mon Oct 30, 2006 4:12 pm, edited 3 times in total.
George D. Paxinos
M998
M1123A2
M998
M1123A2
- almonster
- Sergeant Major of the Gee
- Posts: 357
- Joined: Thu Sep 08, 2005 9:52 am
- Location:
- Contact:
-
- Sergeant Major of the Gee
- Posts: 268
- Joined: Fri Sep 03, 2004 9:57 am
- Location: Central GA
- Contact:
Very nice. I am soon to start a similar project using surplus parts from Diesel depot. We along with the depot are possibly looking to offer an upgrade kit if everthing works out ok. We will se how things work out and let you guys know. I will try to post in progress pictures on our web page.
Shawn Smith
'85 M998 Humvee
Angry Iron Off-road accessories
www.angryiron.com
www.thetruckweb.com
shawn@angryiron.com
'85 M998 Humvee
Angry Iron Off-road accessories
www.angryiron.com
www.thetruckweb.com
shawn@angryiron.com
-
- Sergeant Major of the Gee
- Posts: 268
- Joined: Fri Sep 03, 2004 9:57 am
- Location: Central GA
- Contact:
George could you tell me where your found you Generator, Generator pully, and bracket?
Shawn Smith
'85 M998 Humvee
Angry Iron Off-road accessories
www.angryiron.com
www.thetruckweb.com
shawn@angryiron.com
'85 M998 Humvee
Angry Iron Off-road accessories
www.angryiron.com
www.thetruckweb.com
shawn@angryiron.com
- dilvoy
- G-Lieutenant General
- Posts: 6185
- Joined: Tue May 18, 2004 4:28 pm
- Location: San Francisco, Ca.
serpentine belt installation
Hi Shawn, The alternator and bracket came from Paul Moeller and the pulley is from Chuck at Jeep Acres. Dunsbr picked it up for me along with the P/S pulley, water pump pulley and a bracket. Just incase this helps, the eight groove crankshaft pulley has the Briggs & Stratton logo cast into it. I'm not shure if they just did the casting or the complete manufactrue of the part though.
George D. Paxinos
M998
M1123A2
M998
M1123A2
Who is online
Users browsing this forum: No registered users and 69 guests