RHD conversion

1985 - Present, Questions, discussions, regarding anything related to the Humvee. (NO AUCTION or EBAY)

Moderator: Kurt Lesser

User avatar
dunsbr
G-Lieutenant General
G-Lieutenant General
Posts: 4098
Joined: Thu Dec 09, 2004 2:53 pm
Location: Melbourne, Australia
Contact:

Post by dunsbr » Tue Oct 24, 2006 1:39 am

Hi Jason,

The MRE's there for "Ambiance" :roll:
Same as the radio etc....

Regarding the magic screwdriver it's my special left handed one.
It's magnetised so I can put it in the srew head inside the truck and undo the nut underneath the truck! 8)

Or a Max Smart would say, "Would you believe......" :P

Actually if you look I reworked the entire trans tunnel side to get some more room on what is my drivers side.
I had to cut and rework that panel and make an entire new floor panel.
I picked up 2" extra width by doing that.
The screw driver is sitting in a rivet hole to hold the panel in place while I was working...

Cheers
Brad Dunstan
RHD '87 M1026
(with 4L80E Trans, 242 T/case, 12K hubs, CTIS, A2 wiring, Air Con, A2 ebrake, 9k Winch,
Serpentine Belt Accessory Drive & Eaton e-lockers)


Post Reply

Return to “Humvee Technical Knowledge Base -”

Who is online

Users browsing this forum: No registered users and 50 guests