HMMWV TCM Schematic
Moderator: Kurt Lesser
-
- G-Private
- Posts: 6
- Joined: Wed Aug 16, 2017 7:19 am
- Location:
HMMWV TCM Schematic
I am looking for the schematic for a TCM on a HMMWV. There is 2 grounds on the J2 diagnostic port. I need to know which one is the chassis ground and which is the signal ground. Pin A and F is the grounds.
- Ted Gates
- G-Major General
- Posts: 2667
- Joined: Sun Dec 15, 2002 12:13 pm
- Location: Eaton Rapids, MI
Re: HMMWV TCM Schematic
On TCM J2 connector (6 pin), A goes to TCM J1 A which goes to TCM C2 which is the TCM ground
F goes to TCM J1 F which goes to TCM TCM C1 also labeled as TCM ground
Both C1 and C2 are connected to the wires 599A and 599B which go to the shunt inside battery box.
U / B9 of the TCM is MIL Control earth for the trans check LED lamp.
F goes to TCM J1 F which goes to TCM TCM C1 also labeled as TCM ground
Both C1 and C2 are connected to the wires 599A and 599B which go to the shunt inside battery box.
U / B9 of the TCM is MIL Control earth for the trans check LED lamp.
-
- G-Private
- Posts: 6
- Joined: Wed Aug 16, 2017 7:19 am
- Location:
Re: HMMWV TCM Schematic
Thank you for your response. Yes I have the schematics to. I see that you are correct, however if you look inside the TCM box you will notice that either pin F or A goes directly to ground in the box. The other ground will tie into the big harness of the TCM. The TM's do not cover the wiring inside the TCM box. It only shows the pins on outside of the box. I do not have one laying around to take the cover off.
https://www.ebay.com/itm/Used-Transmiss ... 0005.m1851
https://www.ebay.com/itm/Used-Transmiss ... 0005.m1851
-
- G-Private
- Posts: 6
- Joined: Wed Aug 16, 2017 7:19 am
- Location:
Re: HMMWV TCM Schematic
Here is a pic of what I was looking for.
-
- G-Private
- Posts: 3
- Joined: Thu Jun 29, 2023 12:26 am
- Location: Ukraine
Re: HMMWV TCM Schematic
Excuse me, do you have full pinout for tcm inside melal box?
Who is online
Users browsing this forum: No registered users and 70 guests