Hood Catches and Latches re-attached to hood and fenders, the left hand side latch is original to the jeep, this is how the jeep currently looks as of this week:, I have also done some work since then over the last few days, Bumperettes blasted and primed, distributor stripped, blasted, and primed, also rebuilt the Gennie. Just needs painting. Hope you have enjoyed all of these photographs, this is where I am currently at with the project. Next for 2018, weld in the rear shock absorber mounts to the frame, they were located further back on the CJ, they need to be almost horizontal. get the engine timed and cleaned up, mount the cylinder head etc.., then begin work on the body tub, it needs very little done to it luckily, a good paint stripping and going over with a wire-wheel I think. Look forward to all your comments. I am still missing a fuel tank, brake line kit, new master cylinder, two rear combat rims, need to make a wiring loom, all seats, windscreen etc.., but hoping to get all of that next year, I think 2019 is a realistic time-scale to have it on the road at least.
- IMAG1062-20171230-13570348.jpg (171.4 KiB) Viewed 510 times
- IMAG1065-20171230-135636792.jpg (158.65 KiB) Viewed 510 times
- IMAG1087-20171230-135614334.jpg (148.81 KiB) Viewed 510 times
- IMAG1089-20171230-135547293.jpg (145.27 KiB) Viewed 510 times
- IMAG1091-20171230-135628486.jpg (154.27 KiB) Viewed 510 times
- IMAG1092-20171230-135510130.jpg (128.84 KiB) Viewed 510 times
- IMAG1096-20171230-135438848.jpg (148.56 KiB) Viewed 510 times