I have a few obscure parts to offload and hoping the group might help identify some pieces and it's correct application: Thank you for your insight!
Parts identification request ?
-
- Sergeant Major of the Gee
- Posts: 272
- Joined: Mon Mar 24, 2008 7:08 pm
- Location:
-
- G-Lieutenant General
- Posts: 3599
- Joined: Fri Dec 13, 2002 2:54 pm
- Location: Sydney, Australia.
- Contact:
Re: Parts identification request ?
Hi mate,
I wonder, pending dimensions, if part A is from the rifle mount on a windscreen frame? I'm not positive, but its my best guess.
Not sure on the other 2 sorry! I down think they are factory or standard g503 parts (or even g503 at all?).
Cheers,
Ian.
I wonder, pending dimensions, if part A is from the rifle mount on a windscreen frame? I'm not positive, but its my best guess.
Not sure on the other 2 sorry! I down think they are factory or standard g503 parts (or even g503 at all?).
Cheers,
Ian.
Australian Jeep Investigator
MB: 131175
GPW: 11730.
GPW: 225290.
Aust trailer: GMH 3- #211
http://www.vintageengines.net
MB: 131175
GPW: 11730.
GPW: 225290.
Aust trailer: GMH 3- #211
http://www.vintageengines.net
- nick peters
- G-Brigadier General
- Posts: 2399
- Joined: Sun Jul 22, 2007 9:55 am
- Location: Leicestershire England
Re: Parts identification request ?
I'm with Ian on that one. I too have serious doubts over what they fit If A is for the gun bracket it looks to be out of proportion. The bracket with the two bolts looks a little like the windscreen catch. But that should be screwed on and does'nt need bolts on a gpw/mb The hook looks similar to the rear seat back retaining hook however originals on mb/gpw's have two mounting holes. SO I just hope you didn't pay anything for them If you expected them to fit a gpw or mb
regards Nick
regards Nick
-
- Sergeant Major of the Gee
- Posts: 272
- Joined: Mon Mar 24, 2008 7:08 pm
- Location:
Re: Parts identification request ?
Yes Nick, fortunately I obtained these with a box of misc items for my build, No harm incurred to my wallet.nick peters wrote:SO I just hope you didn't pay anything for them If you expected them to fit a gpw or mb
regards Nick
The parts were obtained by Garrick Smith some years ago when I first met him at Aberdeen. Unfortunately I lost his contact # and well.. he's not on the board.
"A" measures 3-7/8" long from end to end x 7/8" wide. the remaining two pieces the same scale.
thanks for sharing your info.
-
- G-Staff Sergeant
- Posts: 56
- Joined: Sun Mar 04, 2007 4:27 am
- Location: Hertford, NC
Re: Parts identification request ?
Part "E" looks to be the Hand Crank Handle Clamp from behind the back seat.
Bernard Poppert
'45 Transportation Equipment Co. T-1, ACM 154054
07/14/42 GPW 44272, Dallas, TX, 20125426 (est./Tom W.)
11//43 Willys MBT, S/N 49996, ACM 88995
'45 Transportation Equipment Co. T-1, ACM 154054
07/14/42 GPW 44272, Dallas, TX, 20125426 (est./Tom W.)
11//43 Willys MBT, S/N 49996, ACM 88995
Who is online
Users browsing this forum: No registered users and 69 guests