Removing Diff Carrier Bearings - What Puller to Buy?

1941 - 1945, MB, GPW Technical questions and discussions, regarding anything related to the WWII jeep.

Moderator: Moderator

Removing Diff Carrier Bearings - What Puller to Buy?

Postby rsh253 » Mon Nov 03, 2008 10:42 am

Can anyone suggest where to buy a reasonably priced puller for removing the bearings from a MB differential carrier?

A gear tooth broke off in my rear differential housing and by the time it was over, the pinion & ring gear, all 4 diff gears, and the carrier were damaged and will have to be replaced. From what I've been reading here and in the TM, it sounds like I'll be having to remove & re-install the carrier bearings a number of times to get the shims right.

Thanks.

-Russ
'43 MB
'43 MBT
'43 Maintenance Generator Trailer


Busy spending my kid's inheritance.
User avatar
rsh253
G-Staff Sergeant
G-Staff Sergeant
 
Posts: 67
Joined: Sun May 20, 2007 3:47 pm
Location: Fort Mill, SC

Postby JAB » Mon Nov 03, 2008 8:17 pm

I know nothing about this but thought it was interesting enough to post here as it addresses your question perfectly:

http://www.pirate4x4.com/articles/tech/ ... ler_Review

However, this is the type of tool, along with it's related accessories, that I've used with fairly good results;

http://www.shoptoolsshoptools.com/shopexd.asp?id=174
-Jeff

GR8GPN2U!!!

Image

Image
User avatar
JAB
G-Lieutenant General
G-Lieutenant General
 
Posts: 5721
Joined: Fri Dec 13, 2002 7:25 pm
Location: under the jeep in North Prairie, WI


Return to MB GPW Technical Knowledge Base

Who is online

Users browsing this forum: 051743GPW, Ardbeg10, Bruce W, dfast, Jamie M, joker, marcel van genderen, Mike Wright, nick peters, pkozak1, rsjon and 33 guests