Pretty sure all the lift springs made for the early flat fender CJ also fit the ww2 jeeps.
Rancho has made a set for years: Rancho #RS44120
Anyone have a set they got perhaps on a vehicle they took off to restore to stock height they want to sell?
Send any email to:
Wc57doggieboy@yahoo.com
Thanks!!
CJ2 / CJ3 / MB-GPW lift springs wanted
-
- G-Major General
- Posts: 2577
- Joined: Thu Mar 09, 2006 10:54 am
- Location: Colorado
- Contact:
-
- G-Captain
- Posts: 704
- Joined: Sun Dec 22, 2002 6:47 pm
- Location: Pennsylvania
Re: CJ2 / CJ3 / MB-GPW lift springs wanted
Greetings,
The spring number you inquired about is for the REAR. IS that correct? Don't need the front?
I can check my take-off parts.
BRAD
The spring number you inquired about is for the REAR. IS that correct? Don't need the front?
I can check my take-off parts.
BRAD
-
- G-Major General
- Posts: 2577
- Joined: Thu Mar 09, 2006 10:54 am
- Location: Colorado
- Contact:
Re: CJ2 / CJ3 / MB-GPW lift springs wanted
I need all four (4) springs..
My stock units are sagging. Want a little lift too.
Yea. At the time that's all the numbers I had for Rancho.
I BELEIVE that the RS44020 is the front (Rancho numbers)
And RS44120 is the rear.
You got a set u want to sell?
thanks
Send me a reply off line... I'll be out of town for a few days
Wc57doggieboy@yahoo.com
My stock units are sagging. Want a little lift too.
Yea. At the time that's all the numbers I had for Rancho.
I BELEIVE that the RS44020 is the front (Rancho numbers)
And RS44120 is the rear.
You got a set u want to sell?
thanks
Send me a reply off line... I'll be out of town for a few days
Wc57doggieboy@yahoo.com
Who is online
Users browsing this forum: No registered users and 37 guests