Gauges Readings

[ramilolah]

Thanks George and everyone ... Just a question came into my mind ... In case I decided to completely replace the alternator is there any equivelant 24V 60 amp after market alternator that I can use in my car rather than using the M151 specific alternator? Thanks

[svramselaar]

hello

if you get a alternator of a truck 24 volt with internal regulator it is no problem
only you must set the pulley over and make a new bracket so the belts are in line
take first the pulley from your alternator so you know the diameter of the shaft
if you have a 35 till 50 amps it will work fine
the most alternators have a control light ( one side at contact the other to d+ or 61 )

if you have one and do not know the wiring set a picture of it in the forum and i will look it over for you


george

[ramilolah]

Hi George .... Thanks for the info ... I am taking the car to the auto-zone in about 20 minutes ... I will take few pictures for the alternator and I will post here ... I will check first If I can rebuild it and then we will see what other options I will go for next if the alternator has a severe damage !!! ... Hopefully not !!! ... Thanks

[ramilolah]

Alternator photos 1/2

[ramilolah]

Alternator photos 2/2 ... The only number I could find is the one on the regulator as I think and is: 75780 ... I think the regulator is bad as you can see ... The electrician checked the other parts of the alternator and he claims it is fine and I may only need to replace the regulator ... So, guys any help here? Thank you.

[gunny flip]

I got a regulator one time from Army Jeep Parts
mark

[svramselaar]

hello

i can not see the brand of it bud i think it is this one below
http://www.southernautomotive.com/catal ... ucts_id/65

if you sent this firm a good picture he can help you
the regulator from Fill i think is different

george

[svramselaar]

hi agian

it has the nsn nr 290-01-079-9130
it must be a leece-neville alternator type 3002 ac 60amp 28 volt

below it is on E bay from southern-automotive wholesale this is the factory tad make the generator
http://www.ebay.com/itm/2920-01-079-913 ... 0164281760

tnj murray

http://www.tnjmurray.com/militaryvehicl ... FECB804D17

for the manual see page 134 - 138
http://www.liberatedmanuals.com/TM-9-2920-225-34.pdf
parts manual
http://www.liberatedmanuals.com/TM-9-2920-225-34P.pdf


george

[ramilolah]

Thanks George .. The regulator from TNJ will fit only 3002-AE alternators as per them. The manual says that the alternator similar to mine is 3002-AE and 3002-AD; so how would I determine if mine is either 3002-AE or 3002-AD? Thanks

[svramselaar]

hi

if you take good look below at this link it is for all type`s 3002 series
http://www.southernautomotive.com/catal ... ucts_id/65
the AD - AE - AF
get to the phone and cal them they are nice to talk to
ask them how to see the different of the type you have
and the modification you need
they can sent the right parts to you

george

[ramilolah]

I am replacing the whole alternator with a Mercedes 80 amp 24V alternator. I will fabric a new base for the alternator to fit in the vehicle !!

[svramselaar]

hello

now we are talking good by you

at the rear is
B+ battery wire + positive
B- battery wire - negative
a 61 or D+ control light
W not needed (impulse for rev meter )

below a example
http://www.coolcatcorp.com/faqs/LucasBosch5.jpg

it must have a control light otherwise it will not start charching
one side of the light at the contact switch and the other side at the 61/d+
a 2 watt bulb is used

george

[ramilolah]

Hi George ... Really thanks for the photo and the info .. Actually, I am working on that with the electrician so I do not blow up something else !! !!