M38A1Windshield Hinges

1950 - 1952, M38, questions, discussions, regarding anything related to the M38.
Post Reply
gunslinger
G-Corporal
G-Corporal
Posts: 20
Joined: Tue May 31, 2011 3:50 pm
Location:

M38A1Windshield Hinges

Post by gunslinger » Thu Jan 11, 2018 7:06 am

My windshield on the M38A1 is not at the correct angle due to the hinges being bent. Trying to remove the hinge section that is inside the windshield frame so that I can repair/ replace both the upper and lower components. It seems like the upper is rusted in place inside the windshield frame. Wondering if anyone has a secret to remove these parts without damaging the frame? I've removed the bolts from the bottom of the windshield at the cowl as well as the two on the frame, these are about 8 inches up the frame from the cowl. Soaked it in penetrating oil, so far no good news. Thoughts, suggestions, critic, all welcome.
Todd


gunslinger
G-Corporal
G-Corporal
Posts: 20
Joined: Tue May 31, 2011 3:50 pm
Location:

Re: M38A1Windshield Hinges

Post by gunslinger » Sat Jan 13, 2018 4:48 am

Got it out guys, thanks for all the suggestions, elbow grease, brain power and a lot of spray in lube.

Joe Gopan
Jeep Heaven
Posts: 49841
Joined: Sun Mar 02, 2008 12:37 pm
Location: Proving Ground

Re: M38A1Windshield Hinges

Post by Joe Gopan » Sat Jan 13, 2018 5:38 am

NOS Windshields are scarce. Keep an eye out for NOS M-422 Windshield, they are basically the same except for a screw hole here and there. I am saving one as a spare for possible M-38A1 project.
2011 MVPA PIONEER AWARD - MVPA #1064
HONOR GRAD-WHEELED VEHICLE MECHANIC SCHOOL 1960 - US ARMY ORDNANCE SCHOOL(MACHINIST) ABERDEEN PG 1962 - O-1 BIRD DOG CREWCHIEF - 300,000+TROUBLE FREE M-38A1 MILES
LIFE MEMBER AM LEGION-40/8-DAV
7 MIL SPEC MAINTAINED MV'S
COL. BRUNO BROOKS (ARMY MOTORS) IS MY HERO

James L
Sergeant Major of the Gee
Sergeant Major of the Gee
Posts: 275
Joined: Fri Sep 05, 2008 1:39 pm
Location:

Re: M38A1Windshield Hinges

Post by James L » Sat Jan 20, 2018 3:16 pm

I do have an M38A1. N.o.s. Frame Jlobue47@hotmail.com


Post Reply

Return to “M38 Technical Knowledge Base”

Who is online

Users browsing this forum: No registered users and 39 guests