Page 1 of 1
12 volt "conversion"
Posted: Mon Sep 26, 2011 1:21 pm
by scruffy1
Bubba "converted" my 24volt system by running a lead from the second battery to a 12v coil and replacing the original plugs and wires with a standard CJ set. Also, ran a 12v wire from the same battery to power the brakes, running lights and turn signals. I'm going back to 24v and my question is this: Can I run a 24v ignition system on a standard set of plug wires and plugs? I need time to save up for an original wire/plug set.
Thanks!
Re: 12 volt "conversion"
Posted: Mon Sep 26, 2011 7:56 pm
by Cuz
Yes
Re: 12 volt "conversion"
Posted: Tue Sep 27, 2011 1:49 am
by scruffy1
cool
Re: 12 volt "conversion"
Posted: Sun Mar 11, 2012 2:30 pm
by scruffy1
What about the points and condenser?
Re: 12 volt "conversion"
Posted: Mon Mar 12, 2012 9:10 am
by Cuz
If you have installed a 24 volt distributor as you indicated above then use the correct points and condenser for that distributor.
I'm going back to 24v and my question is this: Can I run a 24v ignition system on a standard set of plug wires and plugs?