Questions for Ramsey Winch installation
-
- G-Staff Sergeant
- Posts: 57
- Joined: Mon Feb 23, 2004 5:38 pm
- Location: Athens, Greece
Re: Questions for Ramsey Winch installation
Well, now that I have your picture, I could build something similar to fit on my twin levers. I am using a round cover plate, and the grommet from the Transfer Case that has the dual holes, so it can be done. Thanks a Lot !
Aris
1952 M38
1952 M38
-
- G-Civilian
- Posts: 1
- Joined: Wed Apr 04, 2012 9:31 am
- Location:
Re: Questions for Ramsey Winch installation
Hi ArisL, My name is LOU.. I'm new to this forum - but have a 1952 M-38 also. I have the same problem you were having with the Ramsey 200 winch and the Ramsey PT-1S PTO. I am trying to find out what the easiest way is to support the long driveshaft - do you have any suggestions on what type of hangar bearing to use ? Also, any information on the type and size of u joints would also be helpful. I have 3/4" shafts (long and short) with 3/16" keeways. The 3 ujoints I have seem to work except at the Winch output drive shaft - seems a little too big in diameter (approx 2") up there near the mounting frame . Any help would be appreciated... thanks lou
Who is online
Users browsing this forum: No registered users and 36 guests